Pouco conhecido Fatos sobre harvest right Canada.

In any case, maybe it will help some newbie HR Freeze Dryer owners to answer some of the questions I once had.

These advertising-free forums are provided free of charge through donations from Society members. Anyone may read the forums, but to post you must create a free account.

Long ago. and B. I don't have the test equipment I did then. I guess what I'm saying is don't be afraid to get too technical with me in your answers. What I wouldn't give for a helium leak detector right now...

Taking the time to be sure accurate air flow, drainage angle, and positioning of accessories such as drip pan can avoid mishaps, preserving you the two time and expense In the long term. A properly-executed set up is the initial step toward productive freeze drying adventures.

Removing the ice from between the chamber wall and the insulation (hopefully will never have to do this again)

Of course, if someone used a larger can, say a #10, that is bigger than the top of the container that surrounds the filter and captures the oil, then the "disk" wouldn't be needed at all. In that case, an AN8 fitting might work -- or maybe there are longer ones out there somewhere.

Remove all ice every oito hours of drying time. It is amazing how much faster the drying time drops doing this. A side benefit is water vapor does not contaminate the oil as fast. I've gotten up to 20 cycle per oil change by carefully monitoring the oil and water.

I did have a vacuum hose fitting leak at the FDer port once. I had similar symptoms to yours. I found that the hose would slightly rotate even when the fitting was snug.

It takes slightly extended to dry than our other picks, and it lacks a speed-dry option, but it surely gets the job accomplished and fees various hundred dollars under very similar dryers.

It is fun to experiment with innovative preservation methods, but carefully consider the consumer purchasing points above: Know before you go.

A few packaging methods for your food storage and food that is being preserved. Methods including foil pouches, glass canning, and plastic bottles are discussed.

We use cookies to enhance your browsing experience and analyze our traffic. By continuing to use our sitio, you agree to our use of cookies as described in our privacy policy.. If you wish to opt-out of cookie usage, you can do so by clicking “Opt-Out".

I found out the hard way about the anti-drainback seal when I first tried the filter Buy Now and got... nothing. I did do some research afterward and learned, as you point out, that there are some filters than don't use the seal but by then I was committed. Fortunately, it wasn't all that hard to remove it, but definitely better not to have to.

12 Posted September 16, 2015 You've given me an idea. I have the parts at the shop to use an actual filter head and a spin on filter. I could have a bracket laser cut and powder-coated that would hold the filter/head assembly horizontal which would allow it to completely drain and the outside of the filter would stay clean.